ABS module part number · Hybrid actuator · Toyota / Lexus format
44050-48190 — ABS module part number(Toyota Highlander Hybrid (MHU23/MHU28), 2006-2007)
44050-48190 is listed for the 2006-2007 Toyota Highlander Hybrid (MHU23/MHU28). This unit is quoted first — send a photo of the label and your VIN, and we confirm the work and the price before anything ships.
- Unit: Hybrid actuator
- 1 vehicle line
- 4 fault codes
- Replaced by a later number
Vehicles that use 44050-48190
Each line as the source states it. Parts-catalog sources are linked; confirm against the label on your own module.
| Make | Model | Years | Unit family | Note |
|---|---|---|---|---|
| Toyota | Highlander Hybrid (MHU23/MHU28) | 2006-2007 | Hybrid brake actuator (brake booster with pump) | ACTUATOR Assembly, Brake; 2006-2007 Highlander 3.3 (3MZFE), chassis MHU23L/MHU28L (the hybrid chassis codes); replaced by 44050-48191; requires dealer programming after installation source ↗ |
What this number tells you
Label format · Toyota / Lexus
Five characters, a dash, five more (44050-06070). 44050 is Toyota’s number for the brake actuator assembly — the ABS/VSC hydraulic actuator, usually with the skid-control ECU and pump; 44540 and 44500 numbers are actuator-with-pump variants. source ↗
e.g. 44050-06070 · 44050-0C430 · 44050-42B21 · 44540-06010
Spaces, dots and dashes do not matter: 44050-48190 is the same number however it is printed. A label often carries both the vehicle maker's number and the supplier's own number for the same module — either one identifies it.
Replaced or replacing
44050-48190 is listed as replaced by 44050-48191.
Either number goes on the same bench at the same price — send the one printed on your label.
Known failures on this unit
What brings a Hybrid actuator to the bench, in general terms:
- ●Brake system warning and ABS lights together on a hybrid
- ●Pump running constantly or brake-pressure faults
- 2006-2007 Toyota Highlander Hybrid (MHU23/MHU28)
Toyota T-SB-0032-16 covers 2006-2007 Highlander HV: brake/ABS/TRAC lights with C1391/C1252/C1253/C1256 from a small internal brake fluid leak inside the brake actuator; repair = replace the actuator. source ↗
Fault codes seen on these vehicles
As the sources state them for the vehicle lines above. A code says where to look — the module is the cause when it returns after the fuses, grounds, connector and wheel-speed sensors check out.
| Code | Meaning | Vehicle |
|---|---|---|
| C1391 | Brake actuator internal fluid leak condition (with C1252/C1253/C1256) per Toyota T-SB-0032-16, which applies to 2006-2007 Highlander HV source ↗ | Toyota Highlander Hybrid (MHU23/MHU28) |
| C1252 | Brake booster pump motor failure | Toyota Highlander Hybrid (MHU23/MHU28) |
| C1253 | Brake booster pump relay failure | Toyota Highlander Hybrid (MHU23/MHU28) |
| C1256 | Accumulator low pressure | Toyota Highlander Hybrid (MHU23/MHU28) |
Repair, refurbished or new: your options for 44050-48190
The new-part price is the part alone, from an online parts catalog, as of October 2026.
Repair your 44050-48190
Quote
Free quote first
- Your own module, repaired and tested on the bench
- Keeps your VIN and coding — it is your module
- About 1 week on the bench; rush 2–3 business days for +$100
- 1-year warranty on our work, from the day we ship it back
Refurbished unit with your data
Quote
Free quote first
- A refurbished unit of the same family, tested on the bench
- Your VIN, coding and configuration written in from your original
- Your original stays with us as the core — no separate core charge.
- About 1 week on the bench; rush 2–3 business days for +$100, once your original arrives
No advance exchange: your original module has to reach the bench first, because your vehicle’s data (VIN, coding and configuration) is read out of it and written into the refurbished unit. That is what lets the refurbished module install like your own.
New 44050-48190 (part only)
$1,703.29
catalog price, as of October 2026 source ↗
- A new unit from a parts catalog — the part alone
- Not coded to your vehicle — set up after install per the maker's procedure
- Shipping time and warranty as the parts catalog states them
Plus return shipping from $29.95. The label to our lab is prepaid. Starting prices. If the bench finds more work than your service covers, we tell you the cost and you approve it before we do it. Some vehicles still need a brake bleed, initialization or calibration after install.
What to ship
What comes out depends on the unit. Send us a photo of it before you pull anything and we confirm what to ship.
Write your RMA number on the box and use the prepaid label we e-mail you after checkout — step-by-step mail-in instructions.
Related part numbers
Other numbers on the same vehicle lines — the closest to 44050-48190 first.
- 44050-481912006-2007 Toyota Highlander Hybrid (MHU23/MHU28)
- 04003-451482006-2007 Toyota Highlander Hybrid (MHU23/MHU28)
44050-48190 questions
Can 44050-48190 be repaired instead of replaced?
Hybrid actuator units are a different bench job, so they start with a free quote: send a photo of the label and your VIN and we tell you what can be done and the price before you ship anything. Nothing is charged until you approve the quote.
Which vehicles use 44050-48190?
It is listed for the 2006-2007 Toyota Highlander Hybrid (MHU23/MHU28). The note on file reads: ACTUATOR Assembly, Brake; 2006-2007 Highlander 3.3 (3MZFE), chassis MHU23L/MHU28L (the hybrid chassis codes); replaced by 44050-48191; requires dealer programming after installation. Match the number on your own module label rather than the year alone — different numbers usually separate model years, drivetrains and option packages.
Will I need programming after the repair?
Your VIN and coding come back on the module, so there is no dealer programming visit for it — but installation still follows the vehicle maker’s procedure, including any brake bleeding, initialization or calibration your vehicle requires. A refurbished unit gets your VIN, coding and configuration cloned from your original before it ships, so the same applies to it.
How much does the 44050-48190 repair cost?
It is quoted first, and the quote is free. Hybrid actuator units are not sold at a fixed price online; send the label photo and your VIN and we confirm the price before you ship. Return shipping starts at $29.95 and the label to us is prepaid.
What if it cannot be repaired?
Because this unit is quoted first, nothing is charged until you approve the quote. If the bench then finds it past repair, we tell you before doing anything else: you choose a quoted replacement with your data cloned onto it, or your unit back with the repair price refunded minus shipping costs and a $150 bench evaluation fee.
The lab
ABS Module Lab
1168 W Pioneer Parkway
Arlington, TX 76013
- Phone and text: (817) 505-4201
- Email: repairs@absmodulelab.com
- Hours: Mon–Sat 9:00 AM–7:00 PM Central
Mail-in only — ship your module to the address in your order e-mail, not to the bench.
44050-48190 on your label? Send a photo — the quote is free.
Look up your part number and order online — we email you a prepaid label to our lab. Or send us a photo of the label and your VIN first, and we'll tell you what you have and what it costs.
Back with your VIN and coding · can’t be repaired? repair price back, minus shipping and a $150 bench evaluation fee · 1-year warranty · rush 2–3 days +$100
Call (817) 505-4201 · 📱 Text us a photo of the module label · Confirm my module first — free · Email repairs@absmodulelab.com
