ABS Module Lab

Jeep · repair from $499

Jeep ABS module repair

Every Jeep line we've mapped — 9 vehicle lines from 1997–2021 and 146 sourced part numbers — with the ABS unit each one uses. Repair your own module from $499; it comes back with your VIN and coding, no dealer programming.

Water splashing around the front tyre of a boxy off-road SUV crossing a creek (illustration for Jeep ABS module repair)

Model not listed? We repair Jeep ABS modules beyond this list — start an any-make repair or send us the label.

Known Jeep ABS failures

What the sources report for these models, before anything else is replaced.

  • 1999-2004 Jeep Grand Cherokee (WJ)

    The ABS control module is 'a common issue with Cherokees' (rebuilt units about $100); other ABS-light causes to rule out first are a blown ABS pump fuse, bad wiring at the pump or wheel sensors, and brake-dust-fouled wheel sensors. source ↗

  • 2005-2010 Jeep Grand Cherokee (WK)

    'C2200 - control module internal fault' and 'No communication with ABS control module' for its 2010-2016 multi-Jeep control-module repair; its 2006-2016 pump repair lists low-voltage faults, pump motor power-supply faults, pump motor fault, no communication, faulty control module and pressure sensor faults.

  • 2008-2012 Jeep Liberty (KK)

    Repaired module needs no programming.

  • 2007-2018 Jeep Wrangler (JK)

    'Fault code C2200 signifies an internal failure in your Jeep's ABS module' (2010-2016 Wrangler); replacement modules are described as 'extremely costly and often backordered'.

  • 2018-2020 Jeep Wrangler (JL)

    No sourced JL-specific failure mode for the module hardware was found. FCA's published JL ABS bulletins are software flashes: C2206-00 configuration mismatch after re-gearing past 4.5:1 (TSB 08-099-23) and C055F-00 hydraulic-unit performance (TSB 08-032-22), both on the 4xe. source ↗

Reading a Jeep ABS part number

Mopar (Chrysler / Dodge / Jeep / Ram) - current 68xxxxxx

Eight digits followed by a two-letter revision suffix, e.g. 68259556AD. AA is the original release and the suffix advances AB, AC... as the part is revised. source ↗

e.g. 68259556AD · 68067457AA · 68438389AB

Mopar (Chrysler / Dodge / Jeep / Ram) - legacy 5xxxxxx

Older Chrysler numbers are a 7- or 8-digit numeric string plus a two-letter revision suffix (e.g. 5083285AA). A leading zero is only a catalog formatting prefix: 5083285AA and 05083285AA are the same part. source ↗

e.g. 52126282AC · 05179771AA

Mopar - older suffix-less numbers (1990s modules)

Some 1990s Chrysler ABS parts are catalogued with a bare 8-digit number and no two-letter revision suffix, e.g. 56026812 and 52004508 (1994-1997 Ram 1500 RWAL module / HCU in the Mopar catalog). source ↗

e.g. 56026812 · 52004508 · 56027271

ATE / Continental Teves (supplier number, all brands)

Read as 10.0xxx-xxxx.x: control units 10.0960-/10.0961-/10.0926-/10.0948- with '.3', hydraulic units 10.0212-/10.0204-/10.0399- with '.4'. Often run together as 11 digits.

e.g. 10.0960-0818.3 · 10.0961-0820.3 · 10.0212-0044.4

ABS codes seen on Jeep models

  • C2116 — ABS Pump Motor Supply Low Voltage
  • C2200 — ABS module internal failure - Code C2200 ABS module internal failure'
  • C2200-49 — Anti-Lock Brake Module Internal Fault
  • U0121 — Lost communication with ABS Module
  • C2100 — Battery voltage low
  • C2101 — Battery voltage high
  • 32 — Rear speed sensor circuit
  • C055F-00 — ABS Hydraulic Unit Performance - FCA TSB 08-032-22 Rev. A (2021 JL 4xe 2.0L PHEV, sales code ECX); software flash corrects a stored fault, active fault follows normal diagnostics
  • C100A — ABS wheel speed sensor fault
  • C1020 — Wheel speed sensor fault
  • C2206-00 — Vehicle Configuration Mismatch - FCA TSB 08-099-23 (2021-2022 JL 4xe 2.0L PHEV, sales code ECX): can set after re-gearing past 4.5:1; fixed by ABS software flash
  • U0415 — Invalid data from the ABS module

Jeep ABS module questions

Which Jeep ABS modules do you repair?

This page lists 9 Jeep vehicle lines from 1997–2021, built around 6 ABS unit families. Models outside the list are taken too — order the any-make repair and we identify the unit from the label.

How much is Jeep ABS module repair?

Repair of your own module starts at $499; a replacement unit with your data cloned starts at $950. Return shipping starts at $29.95; the label to us is prepaid.

Where is the part number on a Jeep ABS module?

On the label of the electronic module itself. Eight digits followed by a two-letter revision suffix, e.g.

The lab

ABS Module Lab

1168 W Pioneer Parkway
Arlington, TX 76013

View on Google Maps

Mail-in only — ship your module to the address in your order e-mail, not to the bench.

ABS light on? Fix the module you already own.

Look up your part number and order online — we email you a prepaid label to our lab. Or send us a photo of the label and your VIN first, and we'll tell you what you have and what it costs.

Back with your VIN and coding · can’t be repaired? repair price back, minus shipping and a $150 bench evaluation fee · 1-year warranty · rush 2–3 days +$100

Call (817) 505-4201 · 📱 Text us a photo of the module label · Confirm my module first — free · Email repairs@absmodulelab.com